|
ENGLISH - 89 MaintenanceAbout indicator statusIf an indicator turns onIf a problem occurs within the projector, it will be notified with the temperature indicator , the filterindicator , the shutter indicator */AV MUTE*>, and the lamp indicator .Check the status of the indicators and take the following action.* indicator (Only for EZ570 series, EW630 series and EX600 series.) indicator (Only for EW530 series and EX500 series.)CAUTIONBefore you take a remedial measure, follow the procedure of switching the power off indicated in “Turning off the projector”.z(Æpage 39)If multiple indicators light or blink, verify the status of the projector by looking at each indicator.zNoteConfirm the status of the power indicated on the indicator.zWhen operating correctlyJThe status of the indicator is displayed with the following symbols.: Off, : On, : Flashing, : Off or On or FlashingIndicatorsStatus of the projectorSTANDBY(R)>Green/Red/OrangeRedOrangeAV MUTE>BlueOrange// The power plug has been removed from theoutlet.// *1 *1 *1 *1The projector is in the standby mode.Turns on when pressing the button on the remote control or the < >button on the side control.// *1 *1 *1 *1 The projector is operating normally.//*2 *1 *1 *1 *1The lamp is cooling down. The projector doesnot turn on when pressing the button on the remote control or the < > buttonon the side control until the standby indicator<ON(G)/STANDBY(R)> changes to red.*2// *1 *1 *1 *1The projector is in the power managementmode. The lamp will turn on when controlling theprojector, allowing the user to start operating it.//*2 *1 *1 *1 *1 Power management mode is [On] and the lampis cooling down.// *1 *1 *1The shutter function has been turned on.Press any button on the remote control or theside control to cancel the function.// *1 *1 *2 *1The projector is in the shutter managementmode. The lamp will turn on when controlling theprojector, allowing the user to start operating it.//*2 *1 *1 *2 *1 Shutter management mode is [On] and the lampis cooling down.*1: The indicator will change according to different conditions, regardless of the status of other indicators.*2: The indicator will flash in approximately 1-second intervals.
|
