SettingENGLISH - 65 SettingsHDMI setupThis function is only used for HDMI input source.Press ▲▼ to select [HDMI setup].1 )Press ► or the button.2 ) The names for the output setting of Digital R/G/zB vary from equipment to equipment.HDMI signal levelJ64-940 When the output of Digital R/G/Bequipment is set to Standard.0-1023 When the output of Digital R/G/Bequipment is set to Enhanced.SoundJHDMI When Digital input source is input,Sound is set to HDMI.AUDIO 1 When DVI input source is changedto HDMI input source, Sound is setto AUDIO 1.NoteFor details, refer to the operating instructions of yourzDigital R/G/B equipment.DVI signal levelThis function is only used for DVI-D input source.Press ▲▼ to select [DVI signal level]1 )and then press the button.Press ▲▼ to switch the item.2 )16-235 When you want to enhancethe weaken signal.0-255:PC When in normal condition.Lamp powerThis function allows you to change brightness of thescreen.Press ▲▼ to select [Lamp power] and1 )then press the button .Press ▲▼ to select one among the2 )modes as below.Auto Brightness according to the inputsignal.Normal The lamp power output ismaximum.Eco1 The lamp power output is 80%of the Normal mode.Eco2 The lamp power output is 30% -80% of the Normal mode.Fan controlPress ▲▼ to select [Fan control] and1 )then Press button.Press ▲▼ to select one among2 )options as below.Choose the running speed of cooling fans fromzthe following options according to the groundelevation under which you use the projector.Off Normal speed.*1On 1 Faster than [Off] mode.*2On 2 Faster than [On 1] mode.*3Set this function to [Off] when using the projector*1 :in non-high altitude environment.Select [On 1] when using the projector in high*2 :altitudes (about 1 000 m ~ 2 000 m or moreabove the sea level) where the fans have lesscooling effect.Select [On 2] when using the projector in higher*3 :altitudes (about 2 000 m ~ 2 700 m or moreabove the sea level) where the fans have lessercooling effect.NoteFailure to set the running speed of cooling fanszproperly may affect the projector life.The fan noise becomes louder in [On 1] and [On 2].z
