ENGLISH -41Basic OperationProjectingCheck the connections of the peripheral devices and connection of the power cord (Æpage36) and switch on thepower (Æpage38) to start the projector. Select the image and adjust the state of the image.Selecting the imageSelect an input signal.Side Control/Remote Control OperationJYou can press the button on the side control or the remote control to select INPUT 1/2/3 as inputsource.Remote Control OperationJPress the , , or button on the remote control. Each time you press the 1/2/3> button, the input signal will be changed.AttentionImages may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Select azsystem format that is suitable for the input signal [Y, Pb/Cb, Pr/Cr ] or [RGB] in the [Input] menu (Æpage50).Check the aspect ratio of the screen and the image and select the optimum aspect ratio under the [Screen] menuz(Æpage59).Adjusting the imageAdjusting the position of the lensJPress the button on the remote control or the button on the side control.1)[Lens shift] is displayed on the screen for four seconds.zWhile the display appears, press ▲▼2)◄►to move the image horizontally and vertically.As you move the image, there is a certain position at which the arrows pointing up, down, left and right turn red. Thiszposition is the center for the lens.At positions of maximum shift, the arrows disappear.zThe projector stores the setting made using the lens shift function when the power is turned off.zWhen the position of the image is shifted, the image may become a little darker.zPress and hold the button or button for more than 5 seconds, the lens shift will be return to thezcenter position.The figure below shows an example of when the standard lens is attached.Adjusting the zoom and focusJPress the button and the button on the remote control.1)[Zoom] and [Focus] are displayed on the screen for four seconds.zWhile the display appears, press ▲▼ to adjust the zoom and focus.2)NoteWhen [Display] is set to [Off], the adjustment screen will not appear.zIt is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.zThe display position can beshifted upward up to 60%elevation of the display.When the lens is shifted to top.When the lens is shifted to bottom.When the lens is shifted to leftmost.When the lens is shifted to rightmost.The display position can beshifted downward up to 60%low level of the display.The display position can beshifted to the left in up to10% width of the display.The display position can beshifted to the right in up to10% width of the display.Lens shift
