SettingENGLISH - 67 SettingsSimple modeThis function decides whether to activate the simplemode.Press ▲▼ to select [Simple mode] and1 )then press the button.Press ▲▼ to switch between [On] and2 )[Off].On Simple mode function is off.Off Only the simple mode buttonsare active.NoteWarning icon andz [Simple mode : On] messageappear on the screen for about 4 seconds whenpress the button which is not the simple modebutton.Remote controlThis switching function prevents remote controlinterference when operating several projectors orvideo equipment at the same time.Press ▲▼ to select [Remote control].1 )Press the button.2 )Press ▲▼ to select one among the3 )sixty and five codes.This projector provides 65 different remotezcontrol codes: [All], [Code 01]~[Code 64].NoteWhen operating the projector under [All] code, you canzoperate several projectors at the same time. If you wantto operate the projector independently, you must switchto other code.When different codes are set on the projector and on thezremote control, any operation cannot be made. In thatcase, switch the code on the remote control to fit thecode on the projector.RC sensorSelect a location of the infrared remote receiver of theremote control.Press ▲▼ to select [RC sensor].1 )Press ► or the button.2 )Press ▲▼ to select one among3 )options as below.All Activate all of the receivers.Front &TopActivate both the front and topreceivers.Top &BackActivate both the top and backreceivers.Front &BackActivate both the front and backreceivers.Front Activate only the front receiver.Top Activate only the top receiver.Back Activate only the back receiver.Eco managementCan optimize lamp power and reduce the powerconsumption according to the application.Press ▲▼ to select [Eco1 )management].Press ► or the button.2 )Auto power saveJPress ▲▼ to select [Auto power save]1 )and press the button.Press ▲▼ to choose [On] between2 )[On] and [Off].Press ▲▼ to select auto power save3 )conditions.Ambient lightdetectionAdjusts the lamp power accordingto the ambient brightness.SignaldetectionDrops the lamp power when nosignal is input.AV mutedetection*1Drops the lamp power in the AVmute mode.This function is only for EW530 series and*1 :EX500 series.NoteWhen [Auto power save] is [Off], [Ambient lightzdetection], [Signal detection] and [AV mute detection] arenot available.Only these buttons are activewhen the simple mode is set to[On]. [POWER ON, STANDBY,SHUTTER (AV MUTE), INPUT,MENU, AUTO PC ADJ, ▲, ▼(MUTE), ◄ (VOLUME-), ►(VOLUME+), ENTER, IMAGESELECT, IMAGE ADJUST,P-TIMER, ECO, SCREEN, P INP, ON /OFF]. Number buttonsalso become active only whensetting the remote control codesnumbers or entering the PINcode numbers.
