Panasonic PT-LW375 Operating Instructions Manual

Also see for PT-LB305: Operating instructions

Contents

Panasonic PT-LW375 Operating Instructions Manual Manual pdf 101 page image

ENGLISH - 101Attentionf Do not disassemble the air filter unit.f When attaching the air filter unit, make sure that the projector is stable, and work in an environment that is safe, even in theevent of the air filter unit dropping.f Make sure that the air filter unit is properly attached before using the projector. If it is not attached, the projector will suck indirt and dust causing a malfunction.Notef After cleaning the air filter, reset the filter counter. Otherwise, the actual filter usage time cannot be confirmed.f Replace the air filter unit with the new optional Replacement Filter Unit (Model No.: ET-RFL300) if it is damaged or if the dirtdoes not come off even after cleaning.Replacing the unitLamp unitThe lamp unit is a consumable component. Refer to “When to replace the lamp unit” for details about the replacement cycle.When purchasing the optional Replacement Lamp Unit (Model No.: ET-LAL510), consult your dealer.WarningDo not replace the lamp unit when it is hot. (Wait at least one hour after use.)The inside of the cover can become very hot, take care to avoid burn injuries.Notes on the replacement of the lamp unitf A Phillips screwdriver is necessary when replacing the lamp unit.f Since the luminous lamp is made of glass, it may burst if dropped or hit with a hard object.Handle with care.f Do not disassemble or modify the lamp unit.f When replacing the lamp unit, be sure to hold it by the handle because its surface ispointed and its shape is protruded.f The lamp may rapture. Replace the lamp unit carefully so the glass fragments of thelamp do not scatter. While attaching the projector to the ceiling, do not work rightunder the lamp unit or do not conduct work while your face is near the lamp unit.f The lamp contains mercury. When disposing of used lamp units, contact yourlocal authorities or dealer for correct methods of disposal.Attentionf Panasonic takes no responsibility for any damage or malfunction of the product resulting from use of lamp units which arenot manufactured by Panasonic. Use only specified lamp units.Notef The model numbers of accessories and optional accessories are subject to change without prior notice.When to replace the lamp unitThe lamp unit is a consumable component. Since its brightness gradually decreases over time, it is necessary to replace thelamp unit regularly.Please refer to the displayed time in [Lamp counter] of [Info.] about the usage time of lamp (x page 80).The estimated duration before replacement is 20 000 hours which is displayed in [Lamp counter], but the lamp may gooff before the time above mentioned has elapsed depending on individual lamp characteristics, usage conditions, and theinstallation environment. It is recommended that the Replacement lamp unit be prepared earlier.The time which is displayed in [Lamp counter] is a total time when the real usage time in [ (Normal)], [ (Eco)] or [(Quiet)] is converted to the runtime in [ (Eco)]. Please note that they are not displayed individually.The displayed time in [Lamp counter] = “Lamp runtime of [ (Normal)]” × 2 + “Lamp runtime of [ (Eco)]”+ “Lamp runtime of [ (Quiet)]” × 2The real usage time when the displayed time in [Lamp counter] is 20 000 hours means,When [Lamp control] is constantly set to [ (Normal)] without switching to other modes = 10 000 hoursWhen [Lamp control] is constantly set to [ (Eco)] without switching to other modes = 20 000 hoursWhen [Lamp control] is constantly set to [ (Quiet)] without switching to other modes = 10 000 hoursIf you continue to use the lamp unit after the displayed time in [Lamp counter] 22 000 hours has elapsed, the lamp turns offautomatically at approximately 10 minutes after turning on the power, as it will cause malfunction of the projector.Chapter 6 Maintenance - Maintenance/replacement