ENGLISH - 49Using the Daylight View Lite functionThe Daylight View Lite function improves the vividness of the image even if it is projected under a bright light.button1) Press the button on the remote control.f The Daylight View Lite function will be switched enable/disable each time you press the button.Notef For details, please refer to the [Color adjust] menu → [Daylight View] (x page 60).Setting the remote control ID numbersWhen you use the system with multiple projectors, you can operate all the projectors simultaneously or each projectorindividually by using single remote control, if unique ID number is assigned to each projector.After setting the ID number of the projector, set the same ID number to the remote control.There are seven different ID codes (ALL, Code 1~Code 6), the initial ID number is [ALL].button button1) The ID numbers of the projector are set by pressing the button one time to six times whileholding down the f The number of times you press the button corresponds to the desired ID code number. The number of timesto press the button is as follows:Code 1= Once, Code 2= Twice, Code 3= 3 times, Code 4= 4 times, Code 5= 5 times, Code 6= 6 times.f The ID code is changed when the Attentionf The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote controlis left with dead batteries. Set the same ID number again when the batteries are replaced.Notef Set the ID number of the projector from the [Expand] menu → [Remote control]. (x page 76)f The ID code is reset to [ALL] (default) by pressing the seconds or more.f If the button is pressed seven times or more, the operation is invalid, the ID code cannot be changed.Chapter 3 Basic Operations - Basic operations by using the remote control
