Panasonic PT-LW375 Operating Instructions Manual

Also see for PT-LB305: Operating instructions

Contents

Panasonic PT-LW375 Operating Instructions Manual Manual pdf 82 page image

82 - ENGLISHAbout Memory Viewer function(Only for PT-LW375, PT-LW335, PT-LB425, PT-LB385 and PT-LB355)The Memory Viewer function makes it possible to display the still images stored in the USB memory as projected images.What you can project with the Memory Viewer functionMemory Viewer function supports the following image files.PictureExtension Format Descriptionjpg/jpeg Baseline coding 24 bitsProgressive RGB 24 bitsResolution : 8 x 8 ~ 10 000 x 10 000Resolution : 8 x 8 ~ 1 280 x 800bmp Palette-based 1, 4, 8 bits,RGB 24, 32 bits The maximum resolution : 1 280 x 800png True color 24 bits/48 bits The maximum resolution : 1 280 x 800gif Palette-based 1, 4, 8 bits, Palette - 24 bits color spaces;The maximum resolution : 1 280 x 800tif / tiff — The maximum resolution : 1 280 x 800Notef File size that can be played back is 2 GB at the maximum.f The total number of folders/files that can be recognized on the projector is 500 at the maximum.f Files protected by DRM (Digital Rights Management) cannot be played back.f It maybe impossible to play even if the file is recorded in the supported format.Cautions on using USB MemoryPlease observe the following.f Do not put USB memory or its cap within close reach of children. Swallowing them may cause suffocation.f If the smoke or questionable odor rise, remove the USB memory from the projector, and then contact your dealer.f Do not put water, chemical or oil to the USB memory. It may cause short out or fire.f Do not put foreign objects or put metal objects to the USB terminal. It may cause data loss or data corruption.f Do not remove the USB memory from the projector while data is being read from the USB memory. It may cause data loss ordata corruption.f Do not leave the USB memory in a place with high humidity or dust.f Do not leave the USB memory in a place where static electricity or electromagnetic radiation is generated.Notef It is compatible with the USB memory sold in the market.f It cannot be used the other format other than the formatted with FAT16 and FAT32.Attaching the USB memory1) Attach the USB memory firmly into the terminal.Attentionf Pay attention to the terminal direction to avoid damaging the terminal when attaching the USB memory.f Attach the USB memory directly into the terminal of the projector. Do not use a USBextension cable or USB hub.Removing the USB memory1) Make sure that the indicator on the USB memory is not flashing, and remove it.Attentionf Please note following points when removing the USB memory.- When the indicator of the USB memory attached to the projector is blinking, it indicates that the projector is reading theUSB memory. Do not remove the USB memory from the projector while the indicator is blinking.- When using a USB memory that does not have a monitor function such as an indicator, you cannot check the access statusto the USB memory. In this case, remove it from the projector after closing the memory viewer function or turning off theprojector.- Do not attach and detach the USB memory in a short time. Wait at least 5 seconds after attaching and then remove theUSB memory. If you want to reattach it, wait at least 5 seconds after removal. It takes about 5 seconds for the projector torecognize the USB memory.Chapter 5 Operation of Function - About Memory Viewer function