ENGLISH - 87Attentionf When a LAN cable is directly connected to the projector, the network connection must be made indoors.f When connecting cables to both the terminal and the terminal, it may be difficult to removethe LAN cable which is connected to the terminal. When removing the LAN cable from the terminal, remove acable connected to the terminal or the terminal beforehand.Notef A LAN cable is required to use the wired LAN function.f Use shielded LAN cable (STP cable) that is compatible with category 5 or above.f Use a LAN cable with length of 100 m or shorter.Projector settings1) Use the LAN cable (Straight) to connect the projector with computer.2) Turn on the projector.3) Set the [Expand] menu → [Network] → [Network setting].f For details, refer to the [Expand] menu → [Network] (x page 75).Notef Please confirm with your network administrator before you connect to an existing network.f The wired LAN and wireless LAN cannot be used in the same segment.f The following is preset as the factory default setting.[DHCP] Off[IP address] 192.168.1.100[Subnet] 255.255.255.0[Gateway] 192.168.1.1[DNS] 192.168.1.1Computer setting1) Turn on the computer.2) Make the network setting according to your system administrator.f If the projector settings are the default settings, the computer can be used with the following network settings.[IP address] 192.168.1.101[Subnet] 255.255.255.0[Gateway] 192.168.1.1When connecting via wireless LANThe wireless module (Model No.: ET-WML100) of the optional accessories is required if you want to use the network functionthrough the wireless LAN.f Only one projector can be connected with the wireless LAN.Connection exampleIEEE802.11b/g/nWireless module of optional accessories(Model No.: ET-WML100)Preparation and confirmation of the projector1) Turn on the projector.2) Attach the wireless module (Model No.: ET-WML100) of optional accessories firmly into the (VIEWER/WIRELESS)> terminal.Chapter 5 Operation of Function - Network connection
