Panasonic PT PT-DW5100EL Operating Instructions Manual

Also see for PT-D5700E: Information sheet Service manual Service manual

Contents

Panasonic PT PT-DW5100EL Operating Instructions Manual Manual pdf 13 page image

13 ENGLISHVIDEO IN terminal (page 21)An input terminal for video signals. (BNC)S-VIDEO IN terminal (page 21)An input terminal for S-Video signals.(MIN4-pin DIN)This terminal complies with S1 signals andautomatically toggles between 16:9 and 4:3according to the size of input signals.RGB 1 input (RGB 1 IN) terminal (page 21)A terminal to input RGB or YPB PR signals. (BNC)RGB 2 input (RGB 2 IN) terminal (page 21)A terminal to input RGB or YPB PR signals. (D-Sub15-pin female)DVI-D IN terminal (page 21)DVI-D signals are applied to this terminal. (24-pinDVI-D connector)LAN terminal (page 39)This terminal is used to control the projector fromthe PC. (10BASE-T/100BASE-TX compliant)REMOTE1 lN/OUT terminal (page 15)When two or more main units are used in thesystem, they can be connected and controlled withM3 stereo mini jack cable available in the market.REMOTE2 IN terminal (page 52)The user can remotely control the main unit byusing an external control circuit to this terminal.(D-Sub 9-pin female)SERIAL IN terminal (pages 21, 51)Use the RS-232C serial terminal as an alternativeinterface for controlling the projector from your PC.(D-Sub 9-pin female)SERIAL OUT terminal (pages 21, 51)The signal applied to the SERIAL IN terminalappears at this terminal. (D-Sub 9-pin male)RGB 2 INVDSYNC/HDB/P BG/YRR/PSERIALREMOTE 1 REMOTE 2 IN IN OUTLANDVI-D INRGB 1 INVIDEO IN S-VIDEO ININ OUTSide-mountedconnection terminalsLAN terminal (10BASE-T/100BASE-TX)Connect LAN cable.LAN 10/100 lamp (Yellow)Lights up when 100BASE-TXconnected.LAN LINK/ACT lamp (Green)Lights up when connected.Flashes when receiving/sendingsignals.