Panasonic PT PT-DW5100EL Operating Instructions Manual

Also see for PT-D5700E: Information sheet Service manual Service manual

Contents

Panasonic PT PT-DW5100EL Operating Instructions Manual Manual pdf 22 page image

22ProjectionPowering up the projectorWhen using an optional lens, install a projectionlens before powering up the projector. (Refer topage 24.)Remove the lens cover beforehand.Connect the supplied power cord.(220 - 240 V AC, 50 Hz/60 Hz)Press the “ I ” marked side of the MAINPOWER switch to turn on the power.The power indicator lights up red, and the projector isplaced in the standby mode.Press the “ I ” button. [on the main unitor the remote control]The power indicator illuminates in green and soonthe image is projected on the screen.VDSYNC/HDB/P BG/YRR/PSEREMOTE 1 REMOTE 2 IN INRGB 1 INVIDEO IN S-VIDEO ININ OUTMaking adjustment andselectionIt is recommended that the projector be allowed towarm up for at least 30 minutes before anyadjustments are made to the focus.Press the FOCUS button to roughlyadjust the focus of the lens.*Set the projection scheme in“INSTALLATION” setting. (page 36)Select the input signal by pressing theinput selector button to toggle throughRGB1, RGB2, VIDEO, S-VIDEO and DVI-D.Turn the feet, and adjust the tilt of themain unit in the front and rear or leftand right.Use the lens left/right adjustment dial toadjust the direction of the lens. (page 25)Press the SHIFT button to adjust the“SHIFT”.*Press the AUTO SETUP button if theinput signal is RGB/DVI signal. (page 25)Press the ZOOM button to fit the imagesize to the screen size.*Press the FOCUS button again to adjustthe “FOCUS”.*Press the ZOOM button again to adjustthe “ZOOM” and fit the image size tothe screen size.** When operating at the projector, please refer to page24.• If the projector is powered up at about 0 ˚C,a warm-up period of approximately fiveminutes may be necessary to startprojection.The temperature monitor (TEMP) lightsduring the warm-up period.When the warm-up is completed, thetemperature monitor (TEMP) turns off andthe image is projected on the screen.• If the surrounding temperature is very lowand the warm-up period exceeds fiveminutes, the control determines it as anabnormal condition and turns off thepower automatically. If this happens, raisethe surrounding temperature to 0 °C orhigher and then turn the main power “on”and turn the power “on” ( | ).Note