Indicator status Projector statusOff The power plug is not connected to the outlet.RedLitThe power is switched off (in standby mode).Projection will start when the power <v/b> button is pressed.f The setting of the projector is as follows.g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO].f The projector may not operate when the lamp indicator or the temperature indicator isblinking. (x page 107)Blinking*1The power is switched off (in standby mode).Projection will start when the power <v/b> button is pressed.f The setting of the projector is as follows.g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to[NORMAL].f The projector may not operate when the lamp indicator or the temperature indicator isblinking. (x page 107)GreenLit Projecting.Blinking*2The luminous lamp is turned off.The luminous lamp lights when a signal is input or a button operation is performed.f The setting of the projector is as follows.g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [POWER MANAGEMENT] is set to[READY].Blinking*3 The projector is preparing to project.The projector will project image after a while.Orange Lit The projector is preparing to be switched off.The power will be switched off after a while. (Changes to the standby mode.)*1 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off)*2 The indicator flashes in the cycle: 2.0 seconds (light) → 2.0 seconds (off)*3 The indicator flashes in the cycle: 0.5 seconds (light) → 0.5 seconds (off)Notef While the power indicator lights in orange, the fan is running to cool the projector.f For about 90 seconds after the projector is switched off, the luminous lamp does not light up even if the power is switched on. Turn on thepower again after the power indicator lights/blinks in red.f The projector consumes power even in standby mode (power indicator lights/blinks in red). Refer to “Powerconsumption” (x page 125) for the power consumption.Switching on the projectorBefore switching on the projector, make sure all the other devices are correctly connected (Æ page 31) and thelens cap is removed beforehand.2) 1) 3) 3)1) Connect the power cord to the projector.2) Connect the power plug to an outlet.f The power indicator lights/blinks, and the projector will enter the standby mode.3) Press the power <v/b> button.f The power indicator lights in green and the image is soon projected on the screen.Attentionf Be sure to remove the lens cap before starting projection.36 - ENGLISHChapter 3 Basic Operations - Switching on/off the projector
