| 
Using the freeze functionYou can freeze the projected image and mute the sound temporarily, regardless of the playback status of theexternal device.button1) Press the button.f The image is paused and the audio is muted.2) Press the button again.f The image resumes and the audio is output.Notef [FREEZE] is displayed at the lower left of the projection screen in freeze status.Using the auto setup functionThe automatic setup function can be used to automatically adjust the dot clock, clock phase, and image positionwhen the analog RGB signals consisting of bitmap images such as computer signal are input. It is recommendedto input an image with bright white borders at the edges and high-contrast black and white characters when theautomatic adjustment is being performed. Images including half tones like photos and computer graphics are notsuitable.button1) Press the button.Notef You can also use this function with the button on the control panel.f The clock phase may shift even if the automatic adjustment is performed. In such a case, adjust the [POSITION] menu → [CLOCK PHASE].(Æ page 63)f When the input signal is a blurred-edge image or a dark image, it may not be able to be adjusted correctly even if the automatic adjustmentis performed. In this case, adjust the following settings.g [POSITION] menu → [DOT CLOCK] (Æ page 63)g [POSITION] menu → [CLOCK PHASE] (Æ page 63)g [POSITION] menu → [SHIFT] (Æ page 62)f Automatic adjustment may not be performed depending on the computer model and input signal.f Images may be disrupted for a few seconds during automatic adjustment, but it is not a malfunction.f Automatic adjustment can be canceled by pressing any button on the remote control during the automatic adjustment operation.f If the automatic setup function is used while moving images are being input, the adjustment may not be performed properly even for a signalthat can use automatic setup.Using the screen adjustment functionThe [SCREEN ADJUSTMENT] menu can be displayed.You can correct the distortion of the projected image that occurs when the projector is installed tilted or when thescreen is tilted or curved.button1) Press the button.f The [SCREEN ADJUSTMENT] screen is displayed.2) Press as to switch the item.[KEYSTONE] Adjusts any trapezoidal distortion in the projected image.[CONNER CORRECTION] Adjusts any distortion in the four corners of the projected image.[CURVED CORRECTION] Adjusts any curved distortion in the projected image.46 - ENGLISHChapter 3 Basic Operations - Operating with the remote control |
