Orientation Operation AdjustmentVertical (up and down)adjustment.Press the a button. The image position moves up.Press the s button. The image position moves down.Horizontal (right and left)adjustment.Press the w button. The image position moves to the right.Press the q button. The image position moves to the left.Notef Depending on the input signal, if the adjustment of [SHIFT] exceeds the effective adjustment range of the input signal, the position of theimage cannot be changed. Adjust within the effective adjustment range.[DOT CLOCK](Only for COMPUTER1 signal input / COMPUTER2 signal input)Adjust to reduce noise generated when projecting vertical stripes.When projecting a striped pattern, periodic stripes (noise) may occur. In this case, adjust so that the noise is theleast.1) Press as to select [DOT CLOCK].2) Press qw or the button.f The [DOT CLOCK] individual adjustment screen is displayed.3) Press qw to adjust.f The adjustment values are [-32] to [+32].Attentionf Set it before adjusting [CLOCK PHASE].[CLOCK PHASE](Only for COMPUTER1 input / COMPUTER2 input)You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.1) Press as to select [CLOCK PHASE].2) Press qw or the button.f The [CLOCK PHASE] individual adjustment screen is displayed.3) Press qw to adjust the value.f Adjustment value will change between [0] and [+31]. Adjust so that the amount of interference is at aminimum.Notef Certain signals may not be adjustable.f Optimal value may not be achieved if the output from the input computer is unstable.f To project an image signal with dot clock frequency with 162 MHz or higher, noise may not disappear even if [CLOCK PHASE] is adjusted.ENGLISH - 63Chapter 4 Settings - [POSITION] menu
