16PICTURER 15 NRecording Still PicturesRecords still pictures.1 Set the Operation Mode to [REC>>PICTURE] 12 Select the [RECORDING SETUP] 2.3 Set the [PICTURE QUALITY] 3 to desired picture quality.≥Select one of [FINE], [NORMAL], or [ECONOMY].4 To use the flash, Set the [FLASH] on the [RECORDINGSETUP] 4 Menu to [ON].≥In a dark place, will be displayed and the Flash will beavailable. (The display disappears when in a bright place.)5 Press the [MENU] Button twice to exit menu.6 Press the Recording Start/Stop Button.≥The still image is recorded on the Card.ª Display in the Still picture mode: Still picture modeR 0000: Number of remaining recordable picturesF/N/E: Select a picture quality. ( [F]: Fine, [N]: Normal and [E]:Economy)≥The image size is 640 x 480 (VGA).≥If [NORMAL] or [ECONOMY] is selected for recording, mosaic-patternnoise may appear on a playback image depending on the imagecontent.≥The available range of the Flash is approximately 2-3.5 ft (60 to100 cm) in a dark place.≥Record the subject approx.1 .7 ft (5 0 c m ) away from it.≥If the number of remaining recordable pictures is 10,000 or more, theindication will be “9999”.≥ flashes immediately after the Flash is used to indicate that picturescannot be recorded. Wait until it stops flashing.≥The following table shows still image storage capacity for each imagequality settings:The numbers shown in the above table are approximate and may varydepending on picture content.Fine Normal Economy8MB 45 95 19016MB 100 200 40032MB 220 440 88064MB 440 880 1760VOL +- /MENUMODE/VOLMPEG4PICTUREVOICERECPLAYPUSH/SETSELECTPICTURE RECORDPRESS MENU TO EXITRECORDING SETUPOTHER FUNCTIONSRECORDING SETUPPRESS MENU TO RETURNFLASH OFF ONPICTURE QUALITYFINE NORMAL ECONOMYRECORDING SETUPPRESS MENU TO RETURNFLASH OFF ONPICTURE QUALITYFINE NORMAL ECONOMY2,5234111,2,3,46