7Inserting a Card1 Slide the Card Slot Cover 1, and flip it to open.≥Turn off the SD Multi AV Device before inserting a Card.2 Hold the Memory Card placing the cut off corner 2 at theleft and showing the label 3 frontward, and then insert itfully until it clicks.3 After the Memory Card is set, close the Card Slot Cover1.ª Removing the CardOpen the Card Slot Cover and push the top of the Card. The Cardwill pop up a little and allow you to pick it up with your fingers toremove.≥While the Card Access Lamp 4 is on, the following operations shouldnot be attempted: (Such action will damage the Card, cause loss ofrecorded data and cause the SD Multi AV Device to malfunction.)-Open the Card Slot Cover.-Remove or insert the Card.-Operate your SD Multi AV Device.-Remove the battery or unplug the power cable.-Apply vibration or shock.≥Only an SD Memory Card or a MultiMediaCard can be used for this SDMulti AV Device.≥Do not touch the terminals on the back of the card with your fingers.≥If the Card Slot Cover is not closed completely, remove the MemoryCard and re-insert it.≥Electrical noise, static electricity or failure of the SD Multi AV Device orthe card may damage the card or erase the data stored on the card. Itis recommended to save important data onto a personal computer.Using the LCD MonitorRecord and play the video image while viewing the LCD Monitor.1 Put your finger on the protrusion 1 to open the LCDMonitor.2 Adjust the LCD Monitor angle according to the desiredrecording/playing angle.≥The LCD Monitor can rotate a maximum of 180° 2 from thevertical position to the upward direction and a maximum of 90° 3to the downward direction. Forcefully rotating the LCD Monitorbeyond these ranges will damage the SD Multi AV Device.≥If [UPSIDE-DOWN] is selected for [LCD MONITOR] under the [OTHERFUNCTIONS] menu the picture will be displayed upside down.≥Do not carry or store the SD Multi AV Device with the LCD monitorfacing upward. Otherwise, the LCD monitor may be damaged.123132Removing the CardInserting a CardOPEN1212 341