Panasonic SV-AV10 Operating Instructions Manual

Contents

Panasonic SV-AV10 Operating Instructions Manual Manual pdf 6 page image

6Power Supplyª Using AC Adaptor1 Connect the AC Main Lead to the AC Adaptor and the ACmain socket.2 Connect the DC Input Lead to the [DC IN 4.8V] socket onthe SD Multi AV Device.ª Using the Battery1 While holding the [ ] part, slide it to remove theBattery Compartment Cover.2 Press the terminals of the battery onto the terminals ofthe Battery Compartment and set the battery.≥Fit the battery with its label facing upward.≥After the battery is set, close the cover.3 Connect the AC Main Lead to the AC Adaptor and the ACMain socket.4 Connect the DC Input Lead to the [DC IN 4.8V] socket onthe SD Multi AV Device.≥ Power Lamp flashes, and Charging starts.5 Wait until Power Lamp 1 goes off.≥When recharging is completed, Power Lamp goes off.≥Disconnect the DC Input Lead and hold down the [ ] button fortwo seconds or more, and the SD Multi AV Device is turned ON.≥When the Battery Level Indicator indicates [ ], the batterywill run out in a few minutes. Recharge the battery.≥It takes about 120 minutes, maximum for full-charging. (The chargingtimes are for normal ambient temperature (68F°(20° C) /60%). If theBattery is charged at a higher or lower temperature, the charging timemay be longer)≥When recharging, turn the power of the SD Multi AV Device OFF.≥If the Power Lamp flashes quickly (or slowly) when recharging,recharging is not normal. (l 35)≥When the battery is running out while the SD Multi AV Device is beingused, the Power Lamp starts to flash. Recharge the battery or use theSD Multi AV Device with the DC Input Lead connected.≥If you disconnect the DC Input Lead or the AC Main Lead whilecharging the Battery, Power Lamp flashes several times and goes off.For continuing Battery charge, wait for about 1 minute, and thenconnect the AC Main Lead and the DC Input Lead.THE SOCKET OUTLET SHALL BE INSTALLED NEAR THEEQUIPMENT AND SHALL BE EASILY ACCESSIBLE.CAUTIONDanger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent type recommended bythe manufacturer.Dispose of used batteries according to the manufacturer’sinstructions.DC IN 4.8VRemoving the Battery3 412Using the BatteryDC IN 4.8V1 21