39 IP Address (IP ADDR)The default is "192.168.000.010". Netmask (NETMASK)The default is "255.255.255.000". Gateway (GATEWAY)The default is "192.168.000.001". Switcher Setup (SWITCHERSETUP)Video switcher functions are programmed in this menusetup. Start Display (START DISPLAY)The image in the selected form will be displayed on themonitor when the recorder is turned on.Single image: CH 1 to CH 8Quad image: QUAD-4A (including 1-4), QUAD-4B(including 5-8)Multi image: 9SCREEN (including 1-8)Sequence: SPOT SEQ, MULTI SEQ Multiscreen Selection (MULTI SELMODE)When pressing the [MULTI SCREEN SEL] button on thefront panel, the monitor display will change as followsdepending on the setup.QUAD ONLY: QUAD-4A → QUAD-4B → QUAD-4AALL: QUAD-4A → QUAD-4B → 9SCREEN → QUAD-4A Sequence Setup (SEQUENCESETUP)1. Move the cursor to SEQ SETUP in the SWITCHERSETUP menu, and press the JogDial.The SEQUENCE SETUP menu opens.2. Select either MULTI SEQ SETUP or SPOT SEQ SETUPwith the [D] or [C] button, and press the JogDial. Theselected menu opens. Multiscreen Sequence Setup (MULTISEQ SETUP)Open the QUAD SEQ SETUP menu to program thesequence steps for displaying quad-split and single inputimages.1. Move the cursor to the desired step using the [D] or[C] button.2. Select a camera number with the JogDial, and pressthe JogDial.The default camera number is identical to the step num-ber.Available cameras: From 1 to 8 individually, 4A(1-4), or4B(5-8)Note: The recorder will skip any step assigned "–".3. Select the duration for the step with the JogDial, andpress the JogDial.Available durations: 2-30SSWITCHER SETUPSTART DISPLAY QUAD-4AMULTI SEL MODE ALLSEQUENCE SETUPOCAMERA VIEW SETUPOSEQUENCE SETUPMULTI SEQ SETUPOSEQUENCE TIMING INTAUTO SKIP ONSPOT SEQ SETUPOSEQUENCE TIMING INTAUTO SKIP ONMULTI SEQ SETUPSTEP CAM SEC1 → QUAD-4A 2S2 → QUAD-4B 2S3 → - 2S4 → - 2S5 → - 2S6 → - 2S7 → - 2S8 → - 2S