Panasonic WJ-SX150 Operating Instructions Manual

Also see for WJSX150 - SWITCHER - ADDENDUM: Addendum Addendum manual Operating instructions

Contents

Panasonic WJ-SX150 Operating Instructions Manual Manual pdf 63 page image

65Note: The new character has not been saved in theconfiguration data at this point. After closing theEdit Font window, be sure to return to the CameraTitle window and click on the (Save Exit) but-ton.• To Copy a Character1. Click on the desired character in the User Font box.2. Click on the Copy button.3. Click on the blank in the User Font box to copy thecharacter.4. Click the Paste button.• To Delete a Character1. Click on the desired character in the User Font box.2. Click on the Delete button.3. Click on the Save –> button.■ Data PortThis window configures the parameters of each data port(RS485, DATA 1 to 4 and DATA HDR port): the protocol, thebaud rate (communication speed), and the connectedcameras.● How to DisplayTo display this window, click on the (Data Port) buttonin the main window (p. 52).● Parameters• RS-485 Port GroupProtocol: Select RS485 when an RS-485 camera isconnected to the data port.Select CU360C when the system controller is con-nected to the data port.Select PSD when the system controller is connectedto the DATA 4 port via the PS·Data protocol.PS·Data mode will appear in the window.Baud Rate: Select the desired baud rate (communica-tion speed). 4800, 9600 or 19200 bps is selectable.RS485 Camera Daisy (RS-485 Camera Daisy): Selectthe number(s) of the camera(s) connected to theRS-485 daisy chain.Data 1 to 3 are connectable to either of camerasand system controllers.When connecting cameras to these ports, select theconnected camera number(s).PS·Data mode: This stands for the PS·Data parametersof the DATA 4 port.Logout Time: Select the desired operable timebefore logout. OFF,10, 20, 30, 60, 90 or 120 secis available.The factory default setting is 30 sec.Alarm Data: Select the desired time to accept analarm input signal. OFF, 0, 1 or 5 sec is avail-able.The factory default setting is 1 sec.Wait Time: Select the desired wait time to transmitan alarm output signal. OFF, 100msec, 200m