84tors.SPOT: Spot modeTnn: Tour Sequence mode (nn is the toursequence number.)SET: WJ-SX150 Setup modeALARM: Alarm Active modeACK: Alarm ACK modeVLD H: VLD History TableALM H: Alarm History TableSYS S: System Status TableKB: Lists the system controller number orPC.OPE: Lists the operator numberPRI: Lists the priority number3. To exit from the mode, press the CLEAR button.SYSTEM STATUSMON CAM MODE KB OPE PRI1 01 T01 K1 1 302 02 SPOT K2 2 23 04 ALARM K4 4 14 16 CAM PC 30 1● Moving the Event DisplayMove the joystick while holding down the OSD, SHIFT and3 buttons. (3) will move to the desired direction.● Moving the Monitor Status*Move the joystick while holding down the OSD, SHIFT and4 buttons. (4) will move to the desired direction.* Monitor number, controller number and monitor mode● Moving All the ItemsMove the joystick while holding down the OSD, SHIFT and5 buttons. (1), (2), (3), and (4) will move to the desireddirection.■ System Status TableThe table shows the current system status.1. Select the desired monitor. (Refer to p. 74 MonitorSelection.)2. Press the button 9 while holding down the OSD button."OSD" will appear on the LED display, and the SYSTEMSTATUS table will appear on the active monitor asshown in the figure.The columns in the table indicate the states as shown in thefigure.MON: Monitor numberCAM: Camera numberNo number indicates no camera isselected.MODE: Lists the display mode on the moni-SYSTEM STATUSMON CAM MODE KB OPE PRI1 01 T01 K1 1 302 02 SPOT K2 2 23 04 ALARM K4 4 14 16 CAM PC 30 1SETUP SHIFTREW/FFSTEPCALLPRESETPROGRAMPRESETGROUP SEQPAUSESUSPENDF1CAM SETUP ALL RESETACK RESETF2 TOUR SEQPREV NEXTSTOPOSDAUTO PANRECORDERINDEXSTOP PLAY PAUSECAM FUNCCLEARLOG OUTMON LOCKDEF ONWIPERDEF OFFMON (ESC)T&D CAM IDMON STATUS ALLEVENTALM H VLD H SYS SCAM (SET)MULTI SCREEN SELSEQUENCEAUX2 ONAUX2 OFFEL-ZOOMAUX1 ONAUX1 OFFSTILL