Panasonic WJ-SX150 Operating Instructions Manual

Also see for WJSX150 - SWITCHER - ADDENDUM: Addendum Addendum manual Operating instructions

Contents

Panasonic WJ-SX150 Operating Instructions Manual Manual pdf 88 page image

92■ Tour SequenceThe following functions are available if a tour sequence hasbeen previously configured through SETUP MENU orSX150 Admin Console. Any tour sequence can be assign-ed to any monitors.1. Select the desired monitor. (Refer to p. 91 MonitorSelection.)2. To select the desired tour sequence number, press thenumeric buttons.3. Press the SEQ button to run the tour sequence in theforward direction on the active monitor.4. Press the SEQ PAUSE button to pause a tour sequenceon the active monitor.A series of camera picture appear in pause on the mon-itor screen for the specified dwell time.5. Press the SEQ PAUSE button again to restart a toursequence forward from the next step that was previous-ly paused by pressing the SEQ PAUSE button.6. Press the SHIFT button, and then press the + button tomove the sequence one frame to the next step from thestep that was previously paused by pressing thePAUSE button.Press the SHIFT button, and then press the - button tomove the sequence one frame to the previous step fromthe step that was previously paused by pressing thePAUSE button.7. Select a camera (refer to the system controller's operat-ing instructions) to stop the sequence. The monitor willreturn to the spot mode.■ Group SequenceThe following function is available only if a group sequencehas been previously established in SX150 Admin Console.The group sequence has ID numbers. Group 1 is 17, Group2 is 18, Group 3 is 19, and Group 4 is 20.As described earlier, a group sequence determines theassignment of monitors and cameras. Therefore, monitorselection is not required.1. Press the numeric buttons to select a desired groupsequence ID number, then press the SEQ button.2. Press the SEQ button to run a group sequence forwardon the assigned monitors.5. Press the SEQ PAUSE button again to restart a toursequence forward from the next step that was previous-ly paused by pressing the SEQ PAUSE button.6. Press the SHIFT button, and then press the + button tomove the sequence one frame to the next step from thestep that was previously paused by pressing thePAUSE button.Press the SHIFT button, and then press the - button tomove the sequence one frame to the previous step fromthe step that was previously paused by pressing thePAUSE button.7. Select a camera (refer to the system controller's operat-ing instructions) to stop the sequence. The monitor willreturn to the spot mode.RUNNING SEQUENCE