Panasonic WV-CW970 Service Manual

Also see for Super Dynamic III WV-CW974: Product catalog Product catalog Brochure & specs Specifications Operating instructions

Contents

2-16y After confirming that there is no other object between theCamera and the Radiation Chart, press the ENTER key.u Wait about 40 seconds until finishing the Back Focusadjustment.i Confirm that the picture is clearly visidle during zoomingwide.o If the picture is not clearly viside, press ESC key, andselect the item "1.2. BACK FOCUS ADJ" with theARROW key, and press the ENTER key.!0 Repeat above adjustment steps y to o until the picturebecomes fine.!1 After completing of the adjustment, press the QUIT (F3)key.!2 If you want to save, press the Y key, and then press theENTER key, Type xxxxxxxx.EV2 B40 19FF. Give anappropriate file name for xxxxxxxx within 8 letters, butdo not use CW97C. Then press the ENTER key to finishthis adjustment procedure.!3 If you don't want to save, press the N key, and then pressthe ENTER key to finish this adjustment procedure.4.3 Tilt AdjustmentNote: This Tilt Adjustment is required in the following cases;1. Replacing the CCD Image Sensor.2. Replacing the Sensor Board.3. Replacing the Tilt Board.4.3.1. Starting E.V.R. Adjustment Program8 Insert new floppy disk containing DOS Operating Systemand the E.V.R. Adjustment Program into the computer(IBM PC/AT) and turn on the Power Switch of the com-puter.8 When starting an adjustment, at the prompt, typeRADJ2 CW97TLT and press the ENTER key, an initialmenu page as shown in Fig. 4-3-1 will be displayed.4.3.2. Saving the Adjustment DataThis saving procedure is recommended to keep the currentadjustment status of the camera.8 Press the SAVE (F5) key of the computer, and the com-puter will ask you for the file name.8 Type xxxxxxxx.EV2 B40 19FF. Give an appropriate filename for xxxxxxxx within 8 letters, but do not useCW97C.8 Press the ENTER key.4.3.3. Loading the Adjustment DataThis loading procedure is recommended to return the adjust-ment status of the camera to the factory default setting orthe setting you saved before.8 Press the LOAD (F1) key of the computer, and the com-puter will ask you for the file name.8 Type CW97C.EV2 or xxxxxxxx.EV2 (xxxxxxxx means afile name you named before.) and press the ENTER key.Fig. 4-3-1PANASONIC REMOTE EVR ADJUSTMENT SYSTEM CCTV PRODUCT: CW970 EEPROM:0 MENU Page (1/1) NTSC1. PAN/TILT POSITION-12. PAN/TILT POSITION-23. TILT RE-ADJ4. PAN/TILT POSITION-15. PAN/TILT POSITION-2 PAN/TILT PLEASE CHOOSE MENU DATA BY ARROW-KEYLOAD (F1) QUIT (F3) SAVE (F5)