Panasonic WV-CW970 Service Manual

Also see for Super Dynamic III WV-CW974: Product catalog Product catalog Brochure & specs Specifications Operating instructions

Contents

2-198 Referring to Fig. 4-5-3, reconnect the following connec-tors by using the Extension Cable Ass'y (Refer to Fig.1-4,1-5) for Adjustment.1. Connect the Extension Cable A (Refer to Fig.1-4)between CN201 on the Main Board and the LensAss'y.2. Connect the Extension Cable B (Refer to Fig.1-5)between CN300 on the Main Board and CN500 on theSensor Board.8 Reconnect the Flexible Flat Cable of the Tilt Board(CN400) to CN204 on the Main Board.8 Reconnect the Flexible Flat Cable of the Servo Board(CN1) to CN4 on the Main Board.8 Supply the Power to the WV-CW970/WV-CW974, andthe Camera Head starts panning.8 After the Camera Head stops panning, mount theCamera Head on the CCD Mounting Adjustment Jig asshown in Fig. 4-5-4.Note: Align the small projection of the Camera Head andthe black line on the Upper Plate.8 Adjust the Lens for the fully wide angle position using theRemote Controller.8 Loosen two screws that secure the Sensor Board asshown in Fig. 4-5-5.8 Observing the Monitor Screen, adjust the position of theSensor Board so that the hole on the Bottom Plate comesto the center of the Monitor Screen as shown in Fig. 4-5-6.8 Adjust the position of the Sensor Board so that the hori-zontal black line on the Bottom Plate aligns to the hori-zontal line on the Monitor Screen as shown in Fig. 4-5-6.8 Repeat above adjustment until the hole position remainsat the center of the Monitor Screen while zooming in/outof the Lens.8 Fasten two screws on the Sensor Board.Cross-lineBlack Lineon the Bottom Plate Hole on the Bottom PlateFig. 4-5-6Fig. 4-5-3Fig. 4-5-4Camera HeadCCD MountingAdjustment JigFig. 4-5-5Loosen two screws.SensorBoardCameraHeadFlexibleFlat Cableof theServoBoardCN204CN4FlexibleFlat Cableof theTilt BoardCamera HeadFlexibleFlat Cableof theLens Ass'yExtension Cable AExtensionCable BCN500SensorBoardCN300CN201Main Board