2-174.3.4. Adjustment Procedureq Draw the horizontal line on the center of the VideoMonitor Screen as shown in Fig. 4-3-2.w Select the item "1. PAN/TILT POSITON-1" with theARROW key and press the ENTER key.e Wait until the camera stops moving. (Then camera moves180° pan and 180° tilt.)r Draw the horizontal five lines of 1 mm interval on thepaper as shown in Fig. 4-3-3.t Set the camera from white paper 1.5 m ± 100 mm awayas shown in Fig. 4-3-3.y Adjust the focus becoms fine.Horizontal Line Monitor Screen1.5 m ± 100 mmHorizontal LineWhite Paper1 mmu Move the white paper position so that the center line onthe white paper overlays with the line on the VideoMonitor as shown in Fig. 4-3-4.i Press the ENTER key.o Wait until the camera stops moving. (Then camera moves180° pan and 180° tilt.)!0 Adjust the lens position using E.V.R. Adjustment Kit sothat the center line on the white paper overlays with theline on the Video Monitor as shown in Fig. 4-3-4.!1 Press the ENTER key. (Then camera don't move andauto adjust tilt position.)!2 Press the ENTER key.!3 Wait until the camera stops moving. (Then camera moves180° pan and 180° tilt.)!4 Move the tilt position towards the horizontal line levelusing the E.V.R. Adjustment Kit.!5 Confirm the horizontal line stops at the center line of theVideo Monitor.!6 If the horizontal line stops at the center line, press theESC key and repeat above adjustment steps w - !5.!7 After completing the adjustment, press the QUIT (F3)key.!8 If you want to save, press the Y key, and then press theENTER key. Type xxxxxxxx.EV2 B40 19FF Give anappropriate file name for xxxxxxxx within 8 letters, but donot use CW97C. Then press the ENTER key to finish theadjustment procedure.!9 If you don't want to save, press the N key, and then pressthe ENTER key to finish the adjustment procedure.Horizontal Line Video MonitorWhitePaperCenter LineFig. 4-3-4Fig. 4-3-2Fig. 4-3-3