Panasonic WV-CW970 Service Manual

Also see for Super Dynamic III WV-CW974: Product catalog Product catalog Brochure & specs Specifications Operating instructions

Contents

2-184.4. Preset Data Reset ProcedureNote: This Preset Data Reset is required when Main Boardor EEPROM (IC5 on the Main Board) is replaced.8 Insert new floppy disk containing DOS Operating Systemand the E.V.R Adjustment Program into the computer(IBM PC/AT) and turn on the Power Switch of the com-puter.8 When starting an adjustment, at the prompt, typeRADJ2 CW97PRE and press the ENTER key, an initialmenu page as shown in Fig. 4-4-1 will be displayed.8 Select the item "1. PRESET DATA RESET" with theARROW key.8 When finishing preset data reset, press the QUIT (F3)key then the computer will ask you if you want to save thecurrent adjustment status.8 If you want to save, press the Y key, and then press theENTER key, Type xxxxxxxx.EV2 B40 19FF. Give anappropriate file name for xxxxxxxx within 8 letters, butdo not use CW97C. Then press the ENTER key to finishthis adjustment procedure.8 If you don't want to save, press the N key, and then pressthe ENTER key to finish this adjustment procedure.4.5. CCD Mounting AdjustmentNote: This CCD Mounting Adjustment is required in thefollowing cases;1. Replacing the CCD Image Sensor.2. Replacing the Sensor Board.8 The System Controller should be used.8 Draw the straight cross-line on the surface of the MonitorScreen as shown in Fig. 4-5-1.8 Remove the Camera Head from the Chassis according to2. Disassembling Procedure for Adjustment.8 Referring to Fig. 4-5-2, disconnect the connector CN201on the Main Board and remove the Flexible Flat cable ofthe Lens Ass'y.8 Disconnect the connector CN300 on the Main Board andCN500 on the Sensor Board, and remove the FlexibleFlat Cable.8 Remove one screw that secure the Main Board andremove the Main Board from the Camera Head.PANASONIC REMOTE EVR ADJUSTMENT SYSTEM CCTV PRODUCT: CW970 EEPROM:0 MENU Page (1/1) NTSC1. PRESET DATA RESET RESET PLEASE CHOOSE MENU DATA BY ARROW-KEYLOAD (F1) QUIT (F3) SAVE (F5)Cross-line Monitor ScreenFig. 4-5-1Fig. 4-5-2CN500Camera HeadSensorBoardFlexible Flat CableFig. 4-4-1CN300CN201Main BoardRemoveonescrew.Flexible Flat Cableof the Lens Ass'y