2.7 Configure the alarm settings [Alarm]The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence oralarm images, the VMD area settings, audio detection settings, and the alarm occurrence notification can beconfigured on this page.The “Alarm” page has the [Alarm] tab, the [VMD area] tab, the [Audio detection] tab, and the [Notification] tab.2.7.1 Configure the settings relating to the alarm action [Alarm]Click the [Alarm] tab on the “Alarm” page. (®page 41, page 42)The settings relating to the alarm can be configured in this section. Refer to page 130 and page 128 for furtherinformation about the settings relating to the alarm images and the alarm output terminal.Alarm[Terminal 1]S11x2S11x1S15x1S25x1S22x1S21x1Determine how to use terminal 1.• Off: Not used.• Alarm input(TRM1): Receives alarms. When “Alarm input” is selected, a pull-down menu for “Close” and“Open” is displayed.– Close: An alarm is detected when the terminal status is changed to “Close”.– Open: An alarm is detected when the terminal status is changed to “Open”.• Black & white input: Receives the black & white switchover input. (When the input is set to On, the black& white mode is activated.)• Auto time adjustment: Receives the time adjustment input. When the signal is received and if the clockis within 29 minutes ± the hour, the time will be adjusted to 00 minutes 00 seconds. When the time settingis moved back by less than 5 seconds, the time is not changed. When “Auto time adjustment” is selected,a pull-down menu for “Close” and “Open” is displayed.– Close: The time is adjusted when the terminal status is changed to “Close”.– Open: The time is adjusted when the terminal status is changed to “Open”.• Default: Off[Terminal 2]S11x2S11x1S15x1S25x1S22x1S21x1Determine how to use terminal 2.• Off: Not used.126 Operating Instructions2 Settings
