[Alarm deactivation time]Configure the duration that detections won't be made after an alarm is detected. For example, by using thisfunction you can prevent E-mail from being sent too often when E-mail notifications are configured to be sentto cellular phones when an alarm is detected.5-600s• Default: 5sNote• The duration that alarm detections are not made can be managed for each type of alarm. For example,during the time when detections for command alarms are not made, detections for VMD alarm can bemade.2.7.2 Configure the settings relating to the output terminal[Alarm]S11x2S11x1S15x1S25x1S22x1S21x1Click the [Alarm] tab on the “Alarm” page. (®page 41, page 42)The settings relating to the output terminal can be configured in this section.Output terminalIn order to be able to configure “Output terminal”, “Alarm output” must be selected for [Terminal 2] of the[Alarm] setting.[Terminal output upon alarm detection]Select “On” or “Off” to determine whether or not to output the alarm signals to the output terminal when analarm is detected.• Default: Off[SD memory card error]Select “On” or “Off” to determine whether or not to output signals from the output terminal when an error isdetected for the SD memory card.SD memory card error condition: SD memory card error (write error, read error, etc), Total use time over 6years, and number of overwrites over 2000 times• On: When an error status is detected, the signals from an output terminal is outputted and the [Alarmoccurrence indication] button on the “Live” page blinks.• Off: Deactivates the warning status detection.• Default: OffIMPORTANT• In order to be able to correctly use this function, format the SD memory card with the camera beforeusing it.128 Operating Instructions2 Settings
