[AUX] buttons*2These buttons will be displayed only when “Terminal 3” of “Alarm” is set to “AUX output” on the setup menu.(®page 106)• [Open] button: The letters “Open” on the button will turn green and the status of the AUX connectorwill be open.• [Close] button: The letters “Close” on the button will turn green and the status of the AUX connectorwill be closed.[Rec. on SD] button*2This button will be displayed only when “Manual” is selected for “Save trigger” on the setup menu.(®page 59)Click this button to manually record images on the SD memory card. Refer to page 27 for descriptionsof how to manually record images on the SD memory card.[Log] buttonWhen the [List/Play] button is clicked, the log list will be displayed and images saved on the SD memorycard can be played.Refer to page 33 for further information about the log list and for information on how to play images onthe SD memory card.[Multi-screen]Images from multiple cameras can be displayed on a multi-screen by registering cameras on the setupmenu. (®page 19)[Auto mode]*2Select an operation from the pull-down menu and click the [Start] button. The selected operation will start.Click the [Stop] button to stop the operation. The selected operation will stop when the camera (panning/tilting) is operated or when an action that is to be taken according to the settings for “Selfreturn” (®Page 77) starts.• Preset sequence: Automatically moves to the preset positions (®Page 92) orderly (start from thelowest preset position number).Note• This setting can only be configured when “Cropping [16:9](30fps mode)” is selected for “Imagecapture mode” on the setup menu and the image of button [1] is displayed.Control pad/buttons*2Left-click on the control pad to adjust the horizontal/vertical position of the camera (panning/tilting). It isalso possible to pan/tilt the camera by dragging the mouse.Note• This setting can only be displayed when “Cropping [16:9](30fps mode)” is selected for “Imagecapture mode” on the setup menu and the images of buttons [1] to [4] are displayed.[Preset]*2When a preset position is selected from the pull-down menu and the [Go] button is clicked, the imageregistered for the preset position (®Page 92) in advance is displayed. “H” next to the preset positionnumber indicates the home position. When “Home position” is selected, the camera image will move to thehome position image.The home position of each screen has been set in Preset 1 to Preset 4.Note• This setting can only be displayed when “Cropping [16:9](30fps mode)” is selected for “Imagecapture mode” on the setup menu and the images of buttons [1] to [4] are displayed.Camera titleThe camera title entered for “Camera title” on the [Basic] tab will be displayed. (®Page 50)[Support] buttonWhen this button is clicked, the support site below will be displayed in a newly opened window. This websitecontains technical information, FAQ, and other information.16 Operating Instructions1 Monitor images on a PC
