10.5 Configure the directory of the PC that imageswill be downloaded to [Log]Click the [Log] tab on the “Basic” page. (®page 44, page 46)The directory of the PC that images recorded on the SD memory card will be downloaded to can be configuredin this section.AlarmThe settings related to the directory of the PC that recorded images of when alarms occur will be downloadedto can be performed.[Name of the destination directory for downloaded images]Enter the name of the destination directory to which images recorded are to be downloaded. For example,enter “C:\alarm” to designate the folder “alarm” under drive C.• Available number of characters: 3 - 128 characters• Available characters: Alphanumeric characters, the slash (/), the backslash (\), the colon (:) and theunderscore (_).Manual/ScheduleThe settings related to the directory name of the PC that images recorded by manual saving or schedule savingwill be downloaded to can be performed.Designate the destination folder in the same manner as for “Alarm”.Note• Schedule saving is available only when “H.264(1)”, “H.264(2)”, “H.264(3)”, or “H.264(4)” is selected for“Recording format”.• Ch1 to Ch4 can be selected for H.264(1) when “Cropping [16:9](30fps mode)” is selected for “Imagecapture mode”.FTP errorThe settings related to the directory name of the PC that recorded images of when FTP errors occur will bedownloaded to can be performed.Designate the destination folder in the same manner as for “Alarm”.Operating Instructions 6710 Configure the basic settings of the camera [Basic]