• The information displayed can be sorted by clicking the title of each displayed item.• When the [Network Settings] button is clicked, the “Network Settings” screen is displayed andnetwork settings can be changed. For further information, refer to page 180.3. When the viewer software “Network Camera View 4S” installation screen is displayed, follow the on-screeninstructions to install the software. (The viewer software “Network Camera View 4S” is installed from thecamera.)• The “Live” page of the camera is displayed.• If the viewer software “Network Camera View 4S” cannot be installed or images are not displayed, clickthe [Install] button next to [Viewer Software] from the CD launcher window to install the software.Changing Network SettingsWhen changing settings related to the network settings, such as connection mode, IP address, and subnetmask, click the [Network Settings] button in [IP Setting Software] screen.The “Network Settings” screen is displayed. Enter each item and then click the [Save] button.Note• By unchecking the “Wait for camera restarting.” checkbox, multiple cameras can be continuouslyconfigured.• For further information about each setting of the “Network Settings” page, refer to page 125.IMPORTANT• It may take for around 2 minutes to complete uploading the settings to the camera after clickingthe [Save] button. The settings may be invalidated when the LAN cable is disconnected beforecompleting the upload. In this case, perform the settings again.180 Operating Instructions18 Using the CD-ROM
