6–Fibre Channel Noninteractive Commands-t (FC Target/LUN Information)SN0054667-00 G6-37Where:This feature is supported with 8Gb mezzanine and blade adapters. It is notneeded with the standard QLE2562 adapters.-t(FC Target/LUN Information)To show the target information foralladapters in the system, issue the-tcommand as follows:#qaucli-prfc-t[ ]To show the target information for aspecificadapter, issue the following command:#qaucli-prfc-t(<hbainstance>|<hbawwpn>)To show specific target information for aspecific targeton an adapter, issue thefollowing command:#qaucli-prfc-t(<hbainstance>|<hbawwpn>)(<targetwwpn>|<target portid>)Where:To show the target information on all adapters, issue the following command:-t[<all>]To show the target information on a specific adapter, issue the followingcommand:-t(<hbainstance>|<hbawwpn>)To show the target information for a specific target on a specific adapter, issue thefollowing command:-t (<hba instance> | <hba wwpn>) (<target wwpn> | <target port id>)iiDMA (intelligent interleaved direct memory access) settings include:—targets| –tapplies to all targets.indicates the supported intelligent interleave factor: 1, 2, 4, or8Gbps.hba instance= Adapter number (use the-gcommand to find)hba wwpn= World wide port name of the adapterfile name= Name of the firmware preload table DAT file.hba instance= Adapter number (use the-gcommand to find)hba wwpn= World wide port name of the adaptertarget wwpn= World wide port name of the targettarget port id= Port ID of the target
