7–iSCSI Noninteractive Commands-netconf6 (Configure IPv6 Settings)7-18 SN0054667-00 GSetting the IP address, subnet mask, or gateway turns off DHCP addressresolution for the IP configuration, if it is on.-netconf6 (Configure IPv6 Settings)To manually configure the IPv6 network settings, issue the -netconf6command as follows:-netconf6 <hba_port_inst> [-IP <IPv6 Address>] [-IPNM <SubnetMask> ] [-IPGW <Gateway Address>]Where [option] includes the following:Setting the IP address, subnet mask, or gateway turns off DHCP addressresolution for the IP configuration, if it is on. Some examples of usage follow.To set only the local link address, issue the following command:-netconf6 0 -IPLL fe80::1IP Address> = Set the IP address of the adapter-IPNM Mask> = Set the subnet mask of the adapter-IPGW = Set the gateway address-DISN4 = Disable IPv4 network setup aa Mutually exclusive with the other IPv4 commands-IPV4DHCP = Set DHCP on bb Mutually exclusive with -IP/-IPNM/IPGW-IP = Set IP address-IPNM = Set IP netmask-IPGW = Set IP gateway-DISN6 = Disable IPv6 network setup cc Mutually exclusive with -IPLLA/-IPLL-IPLLA = Automatically set local link address dd Manual or automatic—mutually exclusive-IPLL = Manually set local link address-IPR01A = Automatically set IPR0 and IPR1 ee Manual or automatic—mutually exclusive-IPR0 = Manually set routable address 0 e-IPR1 = Manually set routable address 1 e-IPRRA = Automatically set router address ff Manual or automatic—mutually exclusive-IPRR = Manually set router address fNotes
