4–Installation in a Linux EnvironmentFirmware Upgrades4-24 FE0254601-00 A4. In the right pane, click the FCoE tab (Figure 4-17). The MPI firmwareversion is listed under the Information section.Figure 4-17. Displaying the Adapter MPI Firmware VersionDisplaying the Firmware Version Using sysfsThe sysfs interface is available to advanced users to display the adapter firmwareversion. To display the FCoE adapter firmware version, log in as root, and type thefollowing command, where X is the host number:#cat /sys/class/scsi_host/hostX/fw_version5.03.02 (8d4)To display the MPI firmware version, log in as root, and type the followingcommand:#cat /sys/class/scsi_host/hostX/mpi_version1.40.00 (10400)Upgrading the Boot Code (Firmware)You can upgrade the boot code using the QConvergeConsole or the BIOS andUEFI management utilities.Upgrading the Boot Code Using the QConvergeConsole GUIUpdating the boot code applies to the adapter and not for individual ports. For amulti-port adapter, you can update the boot code (flash image) only through thefirst port.To update boot code using the QConvergeConsole:1. Expand the adapter port number 1, then select the FCoE port.2. In the right pane, click the Utilities tab.
