B–Cisco Nexus 5000 Series Switch ConfigurationEnable FCoE on the SwitchB-2 FE0254601-00 AEnable FCoE on the SwitchTo enable the FCoE function on the switch:1. Determine whether the FCoE function is enabled on the switch by issuingthe show feature command. In the following example, the FCoE functionis disabled.nexusmv1# show featureFeature Name Instance State-------------------- -------- --------fcsp 1 disabledtacacs 1 disabledfc-port-security 1 disabledfabric-binding 1 disabledport_track 1 disablednpiv 1 enabledlacp 1 disablednpv 1 disabledinterface-vlan 1 disabledprivate-vlan 1 disabledudld 1 disabledvpc 1 disabledcimserver 1 disabledfcoe 1 disabledfex 1 enabledIf the FCoE function is already enabled, proceed to “Create and Configurethe VLAN” on page B-3.2. Enter the configuration mode and enable the FCoE function by issuing thefollowing commands:#configure terminal(config)# feature fcoenexusmv1# configure terminalEnter configuration commands, one per line. End with CNTL/Z.nexusmv1(config)# feature fcoeFC license checked out successfullyFCoE manager enabled successfully
