5–Installation in a VMware EnvironmentIdentifying QLogic Adapters Using vSphere ClientFE0254601-00 A 5-116. Display adapter networking driver and firmware versions for QLogic vmnicinterfaces by issuing the following command:# ethtool –i vmnic[N]In this command, [N] is the adapter number that corresponds to a QLogicinterface from the ifconfig –a display (Figure 5-11). A QLogicinterface MAC address begins with 00:0C:DD. The example in Figure 5-12shows networking driver version and firmware version for adapter 3.Figure 5-12. Displaying Networking Driver and Firmware VersionsIdentifying QLogic Adapters Using vSphereClientYou can use the VMware vSphere client to identify Converged Network Adapterson a VMware ESX/ESXi 4.0 host server.To display Converged Network Adapters using the vSphere client:1. Start the vSphere client and select the host you want.2. Click the Configuration tab.3. In the Hardware pane, select Storage Adapters to display all storageadapters, including QLogic Fibre Channel and Converged NetworkAdapters, as shown in Figure 5-13.
