A – Command Line InterfaceShow Command59056-03 C A-93Aport [port_number]Displays operational information for the port given by [port_number]. Ports arenumbered beginning with 0. If [port number] is omitted, information is displayed forall ports. Table A-27 describes the port parameters.Table A-27. Show Port ParametersEntry DescriptionAIinit Incremented each time the port begins AL initialization.AIinitError Number of times the port entered initialization and theinitialization failed.Bad Frames Number of frames that have framing errors.ClassXFramesIn Number of class x frames received by this port.ClassXFramesOut Number of class x frames sent by this port.ClassXWordsIn Number of class x words received by this port.ClassXWordsOut Number of class x words sent by this port.ClassXToss Number of times an SOFi3 or SOFn3 frame is tossed fromTBUF.DecodeError Number of decode errors detectedEpConnects Number of times an E_Port connected through ISL negotiation.FBusy Number of times the switch sent a F_BSY because Class 2frame could not be delivered within ED_TOV time. Number ofclass 2 and class 3 fabric busy (F_BSY) frames generated bythis port in response to incoming frames. This usually indicatesa busy condition on the fabric or N_Port that is preventingdelivery of this frame.Flowerrors Received a frame when there were no available credits.FReject Number of frames from devices that were rejected.InvalidCRC Invalid CRC detected.InvalidDestAddr Invalid destination address detected.LIP_AL_PD_ALPS Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets,performed.LIP_F7_AL_PS This LIP is used to reinitialize the loop. An L_Port, identified byAL_PS, may have noticed a performance degradation and istrying to restore the loop.
