RELM GPH Programming Instruction Manual
Also see for GPH-CMD: OPERATION AND PROGRAMMING
                                                             | |
Contents
| 
RELM Wireless Corporation 11store group two settingsOnce each function 1-5 is set as desired, you can store the changes,discard the changes, or disable all 5 functions.Press the [CLR] key to disable all Group Two functions (steady).Press the [ENT] key to store new Group Two settings into memory andadvance to the next field.Press the [FCN] key to advance to the next field without saving changes.channel 0 group three functions3-- 12345PRGAfter Group Two functions are set, thedisplay will show ‘PRG 3-12345’ for GroupThree functions. As with Group One andGroup Two functions, the enabled functionnumbers will flash. The disabled functionsremain steady.option 3-1 & 2: reserved for future enhancements.option 3-3: backlight on display change3-- 12345PRG When function 3 is enabled (flashing), thedisplay backlight will illuminate each time thedisplay receives input. This includesdisplayed changes in the selected channelor scan channel, and the PR, TX, and SCN annunciators. The displaywill not illuminate if backlight duration is set to LITE OFF. See“Backlight Duration” on the next page.option 3-4: backlight on Key Press3-- 12345PRG When function 4 is enabled (flashing), thedisplay backlight will illuminate each time akey is pressed, even if pressing the key hasno other effect.The display will not illuminate if backlight duration is set to LITE OFF.See “Backlight Duration”. |
Related manuals for RELM GPH-CMD
manualsdatabase
Your AI-powered manual search engine