RELM GPH Programming Instruction Manual

Also see for GPH-CMD: OPERATION AND PROGRAMMING

Contents

RELM GPH Programming Instruction Manual Manual pdf 45 page image

RELM Wireless Corporation 41NOTE: To enable User TGID Pick List Selection, press and hold the‘U’ key “[8] key”. The display will show “UTGID EN”. To disable PickList Selection, press and hold the ‘U’ key again. If Pick List Selection isenabled, but none of the entries has been selected, the radio will usethe default TGID (1) when operating in digital mode.channel labelPRG TX RX SCN D CMND home channelT32 N4 G7PRG TX RX SCN D CMNDCHANNEL 2CHAN LABELThis field is the channel label for channel 1.If this label is correct press the [FCN] key toproceed to the entry point.If a new channel label is desired, follow theinstructions under “Group Label” in section 2.2.1.2.2.After the CHAN LABEL is set, the display will return to the Channel1 starting point. If you wish to review the settings for Channel 1,subsequent pressing of the [FCN] key will show each value and thenreturn to the Channel 1 starting point.At the starting point for Channel 1, the display will show ‘PRG CH 01’.Press the number keys for another channel number to gain access tothe settings for that channel. Each channel is then programmed usingthe same steps described for Channel 1.