RELM GPH Programming Instruction Manual

Also see for GPH-CMD: OPERATION AND PROGRAMMING

Contents

RELM GPH Programming Instruction Manual Manual pdf 23 page image

RELM Wireless Corporation 19talk group Id (Digital Models Only)tg XXXXxPRG TX ID The next field is the Talk Group ID. Thisvalue is only used if the transmit modeselected was Digital or Mixed, or if UserCode Guard is activated. The upper part ofthe display will show ‘PRG TX ID’ and the phone icon. The lower partof the display will show ‘TGXXXXX’ where XXXXX is the Talk Group ID.If the displayed value is correct, press the [FCN] key to advance to thenext field.If you wish to change it, press the [CLR] key followed by the digits forthe new TGID, then [ENT] to store the new value and automaticallyadvance to the next field.secure selection (Encrypted Radios Only)sec xxxPRG TX ID In radios equipped with DES/AESencryption, the next field is the SecureTransmit setting. This selection will notappear in radios that do not have theencryption option.The upper line of the display will show ‘PRG TX ID’, and the lower partof the display will show ‘SEC-XXX’, where XXX can be ‘CLR’ to alwaystransmit a clear signal, ‘ENC’ to always transmit an encrypted signal or‘SW’ where the transmission can be selected via a programmed switch.NOTE: To use the ‘SW’ selection one of the radios toggle switchesor [FCN] menu selection must be programmed with for the ‘TransmitSecure’ selection. These settings require the use of the PC RadioEditor LAA0744X.If the mode is correct, press the [FCN] key to advance to the next field.If a new mode is desired, press the [PRI] key to cycle through themode settings. Press [ENT] to store the new mode and automaticallyadvance to the next field.encryption Key (Encrypted Radios Only)key 01PRG TX ID In radios equipped with DES/AESencryption, the next field is the EncryptionKey setting. This selection will not appear inradios that do not have the encryptionoption.