35Beyond the BasicsOtherwise, press ./CLR if you do not want toselect it.^ When you select the option, press ./CLR to exitthe option mode. Otherwise, to continue normalscanning, repeatedly press FUNC untildisappears then press SCAN.using signal stalkerTo turn on Signal Stalker, turn SQUELCH fullyclockwise, then press FUNC + once except inWX search, band select, or program mode.appears. Every 2 seconds, the scanner searchesfor frequencies in the range you specified in “settingthe signal stalker options” on Page 33.Note: To continue scanning normally while SignalStalker is working, simply press SCAN.When the scanner finds a frequency, it sounds thealert you specified in “setting the signal stalkeroptions” on Page 33, and Found flashes. Press anykey to confirm the displayed frequency. DuringSignal Stalker operation, the delay time is 10seconds. After 10 seconds have elapsed, or if youpress SCAN, the scanner resumes searching. If youfind a frequency you want to monitor continuously,press HOLD to hold the frequency. While in holdmode, you can select the band where you aresearching by pressing or while appears.FF