Rangemaster Kitchener 110 Gas User's Manual & Installation Instructions
Also see for Kitchener 110: User's guide & installation instructionsUsers guide & installation
                                            | |
Contents
|
20ArtNo.330-0003 - Grill pan w handle pulled forwardsArtNo.331-0001Grill pan pulled forwardsArtNo.331-0003 Grill frame out, no panArtNo.331-0004 Removing the grill frameArtNo.331-0005 Removing the grill railArtNo.331-0006 Grill pan planGrillThe grill pan and trivet (Fig.5.5) should be washed in hotsoapy water. Alternatively, the grill pan can be washed in adishwasher.After grilling meats or any foods that soil, leave to soak for afew minutes immediately after use. Stubborn particles maybe removed from the trivet using a nylon brush.nn Before you remove any of the grill parts for cleaning.make sure that they are cool, or use oven gloves.nn Do not use any abrasive substances.Glide-out Grill (Professional +)The face of the grill burner will darken with use – this isperfectly normal. Any fat or grease will burn off. Do not try toclean it – the small holes could get blocked and may affectthe burner performance.The grill pan and trivet should be washed in hot soapy water,alternatively, the grill pan can be washed in a dishwasher.After grilling meats or any foods that soil, leave to soak fora few minutes in the sink immediately after use. Stubbornparticles may be removed from the trivet by using a nylonbrush.The grill pan can be easily removed for cleaning as follows;Remove the grill pan support frame by pulling the grill panforward (Fig.5.6).Lift the grill pan clear of the support frame. The support frameis held to the side rails by two clips on each side (Fig.5.7).For each side, support the side rail with one hand and withthe other hand lift the frame up and out of the side clips(Fig.5.8).For safety, push the side rails back into the grill chamber.If you need to remove the side rails to allow cleaning of thegrill chamber, you can unhook them from the grill chambersides (Fig.5.9) and wipe the sides clean with a soft cloth andmild detergent.DO NOT put the side runners in a dishwasher.Once you have finished, hook the side rails back onto thesides of the chamber. To refit the frame, pull the side railsforward and, for each side in turn, support the side rail andpress the frame down into the side rails. Replace the grill pan.When refitting the grill pan, make sure that the wide rim is atthe front (Fig.5.10).Control Panel and DoorsAvoid using any abrasive cleaners including cream cleaners.For best results, use a liquid detergent.The same cleaner can be used on the doors or alternativelyusing a soft cloth wrung out in clean hot soapy water – buttake care that no surplus water seeps into the appliance.After cleaning, polish with a dry cloth.Fig.5.5Fig.5.6Fig.5.7Fig.5.8Fig.5.9Fig.5.10 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine