21When replacing the linings fit the side liningsfirst.Make sure you fit the oven roof with the slot atthe front.Moving your cookerSwitch off the electricity supply.The cooker is heavy; two people may berequired to move it. The cooker is fitted withone roller at the front and two at the back.There are also two screw down levellingfeet at the front.The front roller, designed for moving the cookercan be wound down. The levelling tool thatcontrols this roller is in the storage drawer.To remove the drawer, pull it right outLift up the ends of the plastic clips (one eachside) to release the catches holding the drawerto the side runners and at the same time pull thedrawer forward and away from the side runners.For safety’s sake push the drawer runners backout of the way.Locate levelling tool as shown. If you cannot findthe levelling tool, contact your installer. See thestart of the ‘Installation’ section of theseinstructions.Turn the levelling tool clockwise, two full(180°) turns. It will be stiff. The front of theoven will rise slightly as the roller dropsdown.Open the grill door and right hand oven door sothat you can get a good grip on the bottom ofthe fascia panel as you move the oven.Do not move the oven by pulling the handrail, door handles or knobs.Move the oven a bit at a time, checking behind itto make sure the gas hose is not caught. Makesure both electricity and gas cables havesufficient slack to move the cooker forward asyou go along.If a stability chain is fitted, release it as youease the cooker out.When you replace the cooker, wind it down offthe rollers by turning the levelling tool anti-clockwise. This is important. It will stop thecooker moving accidentally, while in use.To refit the drawPull out the side runners. Rest the drawer backon the side runners and, keeping it level, push itright back. The clips should click into positionholding the drawer to the side runners.