Chapter 12: Command Line Interface (CLI)216Common Commands for All Command Line Interface LevelsFollowing are the commands that are available at all CLI levels. Thesecommands also help navigate through the CLI.Commands Descriptiontop Return to the top level of the CLI hierarchy, or the“username” prompt.history Display the last 200 commands the user enteredinto the Dominion KX II CLI.help Display an overview of the CLI syntax.quit Places the user back one level.logout Logs out the user session.Initial Configuration Using CLINote: These steps, which use the CLI, are optional since the sameconfiguration can be done via KVM. See Getting Started (on page 13)for more information.Dominion KX II devices come from the factory with default factorysettings. When you first power up and connect to the device, you mustset the following basic parameters so the device can be accessedsecurely from the network:1. Reset the administrator password. All Dominion KX II devices areshipped with the same default password. Therefore, to avoid securitybreaches it is imperative that you change the admin password fromraritan to one customized for the administrators who will manage theDominion KX II device.2. Assign the IP address, subnet mask, and gateway IP address toallow remote access.Note: Both IPv4 and IPv6 addresses are supported.Setting ParametersTo set parameters, you must be logged on with administrative privileges.At the top level, you will see the "Username" > prompt, which for theinitial configuration is "admin". Enter the top command to return to thetop menu level.Note: If you have logged on with a different user name, that user namewill appear instead of admin.
