Chapter 4: Virtual Media85Connecting to Virtual MediaLocal DrivesThis option mounts an entire drive, which means the entire disk drive ismounted virtually onto the target server. Use this option for hard drivesand external drives only. It does not include network drives, CD-ROM, orDVD-ROM drives. This is the only option for which Read/Write isavailable.Note: KVM target servers running certain versions of the Windowsoperating system may not accept new mass storage connections after anNTFS-formatted partition (for example, the local C drive) has beenredirected to them.If this occurs, close the Dominion KX II Remote Console and reconnectbefore redirecting another virtual media device. If other users areconnected to the same target server, they must also close theirconnections to the target server.Note: In Dominion KX II 2.1.0 and above, when you mount an externaldrive, such as a floppy drive, the LED light on the drive will remain onbecause the Dominion KX II is checking the drive every 500 millisecondsto verify the drive is still mounted.To access a drive on the client computer:1. From the Virtual KVM Client, choose Virtual Media > Connect Drive.The Map Virtual Media Drive dialog appears.2. Choose the drive from the Local Drive drop-down list.3. If you want Read and Write capabilities, select the Read-Writecheckbox. This option is disabled for nonremovable drives. See theConditions when Read/Write is Not Available (on page 86) formore information. When checked, you will be able to read or write tothe connected USB disk.
