Chapter 12: Command Line Interface (CLI)217Setting Network ParametersNetwork parameters are configured using the interface command.admin > Config > Network > interface enable true if lan1ip 192.16.151.12 mask 255.255.255 gw 192.168.51.12When the command is accepted, the device automatically drops theconnection. You must reconnect to the device using the new IP addressand the user name and password you created in the resetting factorydefault password section.Important: If the password is forgotten, the Dominion KX II will needto be reset to the factory default from the Reset button on the backof the Dominion KX II. The initial configuration tasks will need to beperformed again if this is done.The Dominion KX II now has the basic configuration and can beaccessed remotely via SSH, GUI, or locally using the local serial port.The administrator needs to configure the users and groups, services,security, and serial ports to which the serial targets are attached to theDominion KX II.Note: Both IPv4 and IPv6 addresses are supported.CLI PromptsThe Command Line Interface prompt indicates the current commandlevel. The root portion of the prompt is the login name. For a direct adminserial port connection with a terminal emulation application, Admin Port isthe root portion of a command.admin >For TELNET/SSH, admin is the root portion of the command:admin > config > network >0CLI Commands• Enter admin > help.Command Descriptionconfig Change to config sub menu.diagnostics Change to diag sub menu.help Display overview of commands.
