Chapter 13: Dominion KX II Local Console234Configuring Dominion KX II Local Port Settings from the Local ConsoleThe standard local port and the extended local port can be configuredfrom the Remote Console on the Port Configuration page or from theLocal Console on the Local Port Settings page. See ConfiguringDominion KX II Local Port Settings (on page 171) for details onconfiguring these ports.Dominion KX II Local Console Factory ResetNote: This feature is available only on the Dominion KX II Local Console.The Dominion KX II offers several types of reset modes from the LocalConsole user interface.Note: It is recommended that you save the audit log prior to performing afactory reset. The audit log is deleted when a factory reset is performedand the reset event is not logged in the audit log. For more informationabout saving the audit log, see Audit Log (on page 192).To perform a factory reset:1. Choose Maintenance > Factory Reset. The Factory Reset pageopens.2. Choose the appropriate reset option from the following options:• Full Factory Reset - Removes the entire configuration and resets thedevice completely to the factory defaults. Note that any managementassociations with CommandCenter will be broken. Because of thecomplete nature of this reset, you will be prompted to confirm thefactory reset.• Network Parameter Reset - Resets the network parameters of thedevice back to the default values (click Device Settings > NetworkSettings to access this information): IP auto configuration IP address Subnet mask Gateway IP address Primary DNS server IP address Secondary DNS server IP address Discovery port Bandwidth limit LAN interface speed & duplex Enable automatic failover
