Chapter 4: KX III Administrator Help176As noted, you may delete a custom profile from the system while it is stilldesignated as an active profile. Doing so will terminate any virtual mediasessions that were in place.Handling Conflicts in Profile NamesA naming conflict between custom and standard USB profiles may occurwhen a firmware upgrade is performed. This may occur if a customprofile that has been created and incorporated into the list of standardprofiles has the same name as a new USB profile that is downloaded aspart of the firmware upgrade.Should this occur, the preexisting custom profile will be tagged as 'old_'.For example, if a custom profile called GenericUSBProfile5 has beencreated and a profile with the same name is downloaded during afirmware upgrade, the existing file will then be called'old_GenericUSBProfile5'.You can delete the existing profile if needed. See USB ProfileManagement (on page 175) for more information.Upgrading CIMsUse this procedure to upgrade CIMs using the firmware versions storedin the memory of your KX III device. In general, all CIMs are upgradedwhen you upgrade the device firmware using the Firmware Upgradepage.To upgrade CIMs using the KX III memory:1. Choose Maintenance > CIM Firmware Upgrade. The CIM Upgradefrom page opens.The Port (number), Name, Type, Current CIM Version, and UpgradeCIM Version are displayed for easy identification of the CIMs.2. Check the Selected checkbox for each CIM you want to upgrade.3. Click Upgrade. You are prompted to confirm the upgrade.4. Click OK to continue the upgrade. Progress bars are displayedduring the upgrade. Upgrading takes approximately 2 minutes or lessper CIM.Upgrading the KX III FirmwareUse the Firmware Upgrade page to upgrade the firmware for your KX IIIand all attached CIMs. This page is available in the KX III RemoteConsole only.
