Chapter 4: KX III Administrator Help362. Connect one end of a DVI cable into the DVI-D port on the back ofthe KX III.3. Connect the other end of the DVI cable into the DVI port on the DVImonitor.Connect to a VGA Monitor (Optional)To connect to a VGA monitor:1. Connect a USB keyboard and mouse to the respective Local Userports on the back of the KX III.2. Plug the DVI-D to VGA converter in to the DVI-D port on the back ofthe KX III, and secure it by turning the screws on each sideclockwise.3. Connect a VGA cable to the DVI-D to VGA converter, connect theother end to your VGA monitor and secure it by tightening thescrews.Note: The DVI-D to VGA converter is not included with the KX III.Contact Raritan Sales for information.E. Connect Target Servers to the KX IIITo connect a target server to the KX III:1. Connect the keyboard, mouse and video plugs on the CIM to thecorresponding ports on the target server.2. Connect the CIM to an available target server port on the back of theKX III via a Cat5/5e/6 cable.F. Tiering (Optional)See Configuring and Enabling Tiering (on page 123,http://www.raritan.com/help/kx-iii/v3.0.0/en/index.htm#33184)Step 4: Configuring the KX IIIFor the following steps, you must change the default password andassign the KX III its IP address at the Local Console.All other steps can be performed from either the Local Console, or fromthe KX III Remote Console via a supported web browser using the KXIII's default IP address.Java® 1.7 (or higher) or Microsoft .NET® 3.5 (or later) is required to useKX III.
