Chapter 5: Virtual KVM Client (VKC) Help228Calibrating ColorUse the Calibrate Color command to optimize the color levels (hue,brightness, saturation) of the transmitted video images. The colorsettings are on a target server-basis.Note: The Calibrate Color command applies to the current connectiononly.To calibrate the color, do the following: Choose Video > Calibrate Color, or click the Calibrate Color buttonin the toolbar.The target device screen updates its color calibration.Adjusting Video SettingsUse the Video Settings command to manually adjust the video settings.To change the video settings:1. Choose Video > Video Settings to open the Video Settings dialog.2. Adjust the following settings as required. As you adjust the settingsthe effects are immediately visible:a. PLL SettingsClock - Controls how quickly video pixels are displayed acrossthe video screen. Changes made to clock settings cause thevideo image to stretch or shrink horizontally. Odd numbersettings are recommended. Under most circumstances thissetting should not be changed because the autodetect is usuallyquite accurate.Phase - Phase values range from 0 to 31 and will wrap around.Stop at the phase value that produces the best video image forthe active target server.b. Brightness: Use this setting to adjust the brightness of the targetserver display.c. Brightness Red - Controls the brightness of the target serverdisplay for the red signal.d. Brightness Green - Controls the brightness of the green signal.e. Brightness Blue - Controls the brightness of the blue signal.f. Contrast Red - Controls the red signal contrast.g. Contrast Green - Controls the green signal.h. Contrast Blue - Controls the blue signal.
