Chapter 4: KX III Administrator Help45Rack PDU (Power Strip) Outlet ControlOverviewThe KX III allows you to control Raritan PX and RPC series rack PDU(power strip) outlets connected to the KX III through a D2CIM-PWR.Once a PX or RPC series is setup and then attached to the KX III, therack PDU and its outlets can be controlled from the Powerstrip page inthe KX III interface. This page is accessed by clicking on the Powermenu at the top of the page.The Powerstrip page will display rack PDUs attached to the KX III forwhich the user has been granted appropriate port access permissions. Inthe case of tiered configurations, the Powerstrip page will display bothrack PDUs attached to the base and tiered KX IIIs, for which the userhas been granted appropriate port access permissions.Note: For information on setting up a PX, see the Raritan PX UserGuide.From the Powerstrip page, you are able to turn the outlets on and off, aswell as cycle their power. You are also able to view the following powerstrip and outlet information: Powerstrip Device Information: Name Model Temperature Current Amps Maximum Amps Voltage Power in Watts Power in Volts Ampere Outlet Display Information: Name - Named assigned to the outlet when it was configured. State - On or Off status of the outlet. Control - Turn outlets on or off, or cycle their power. Association - The ports associated with the outlet.
