Chapter 5: Virtual KVM Client (VKC) Help255Audio Playback and Capture Recommendations and RequirementsAudio Level Set the target audio level to a mid-range setting.For example, on a Windows® client, set the audio to 50 or lower.This setting must be configured through the playback or capture audiodevice, not from the client audio device control.Recommendations for Audio Connections when PC Share Mode isEnabledIf you are using the audio feature while running PC Share mode, audioplayback and capture are interrupted if an additional audio device isconnected to the target.For example, User A connects a playback device to Target1 and runs anaudio playback application then User B connects a capture device to thesame target. User A's playback session is interrupted and the audioapplication may need to be restarted.The interruption occurs because the USB device needs to bere-enumerated with the new device configuration.It may take some time for the target to install a driver for the new device.Audio applications may stop playback completely, go to the next track, orjust continue playing.The exact behavior is dependent on how the audio application isdesigned to handle a disconnect/reconnect event.Bandwidth RequirementsThe table below details the audio playback and capture bandwidthrequirements to transport audio under each of the selected formats.Audio format Network bandwidth requirement44.1 KHz, 16bit stereo 176 KB/s44.1 KHz, 16bit mono 88.2 KB/s2.05 KHz, 16bit stereo 88.2 KB/s22.05 KHz, 16bit mono 44.1 KB/s11.025 KHz, 16bit stereo 44.1 KB/s11.025 KHz, 16bit mono Audio 22.05 KB/s
